Click here to use UnoHelper to easily setup UnoDNS instead.


Setting up UnoDNS on Windows 7


Step - 1:

Open your web browser and go to http://www.unotelly.com/unodns/global

Please note down the two nearest DNS addresses from your physical location.


Note: If you wish to use our new Dynamo feature, please make sure you use Dynamo enabled DNS servers.  

Please refer to this link for more information: What is UnoDNS Dynamo?  


Step - 2: 

Click 'START' and open 'Control Panel'.
 

1.webp


Step - 3:
Under 'Network and Internet', click 'View network status and tasks'.

2.webp

Step - 4:
On the left side, click 'Change Adapter Settings'.

3.webp

 


Step - 5:

If you are using wireless internet:

Right click on 'Wireless Network Connection' and click on 'Properties'.

                                -OR-

If you are using an ethernet/cable connection:

Right click on 'Local Area Connection' and click on 'Properties'.


4.webp


Step - 6:
Choose 'Internet Protocol Version 4(TCP/IPv4)' and click on 'Properties'.

5.webp


Step - 7:
Click on 'Use the following DNS server addresses' and enter the DNS addresses you received by visiting www.unotelly.com/unodns/global in Step 1.
 

step3_original.webp




 
Step - 8 Done!
After that, click 'OK' and close everything. Close all of your browsers to apply the settings as well. Then go to Quick Start to verify that your service is active.